LOOP BPM WAVE
LOOP SELECT / BPM / ZOOM
TIMELINE PRACTICE TOOLS
Loop Playback, Select Wave Time, BPM, and Zoom are grouped because they all control the practice position. Use them to repeat difficult sections, slow down practice, and inspect timing visually.
1. SELECT WAVE TIME
Selected wave time is the range used by Loop, Fade, SFX, silence, and Render operations.
STEP 1 - Click the waveform timeline
Click anywhere on the waveform. The orange playhead jumps to that position and playback can start from there.
STEP 2 - Set the start point
Move the playhead to the phrase start and click the left/start marker button.
STEP 3 - Set the end point
Move the playhead to the phrase end and click the right/end marker button.
STEP 4 - Check the selected range
Confirm the highlighted range covers the exact section you want before applying loop, effects, fade, or render.
2. LOOP PLAYBACK
Loop Playback repeats the selected range. It is for practicing a section, testing timing fixes, or recording repeated takes.
STEP 1 - Click LOOP SELECT
After setting start and end points, click LOOP SELECT to turn loop on.
STEP 2 - Watch the loop result
When playback reaches the end marker, the orange playhead returns to the start marker and repeats the same range.
STEP 3 - Adjust if the phrase is cut
If the loop starts too early, too late, or cuts the phrase ending, move the start/end points and play again.
STEP 4 - Turn Loop off
Click LOOP SELECT again to return to full-song playback.
3. BPM CHANGE
BPM controls change practice playback speed. Slow down difficult parts, then return to normal speed after practice.
STEP 1 - Click BPM minus or plus
Use minus to slow down and plus to speed up. Small changes are easier to practice than large jumps.
STEP 2 - Enter a specific BPM when needed
Click the BPM value if you need a precise number. Play the loop again after changing speed.
STEP 3 - Return to normal speed
When the section feels stable, restore the original BPM and test the same loop again.
4. ZOOM WAVE
Zoom Wave is important for checking Auto Delay, Move Track, fade points, and waveform starts.
STEP 1 - Click ZOOM IN
Click ZOOM IN when the waveform is too small to judge timing.
STEP 2 - Inspect the waveform closely
Compare the selected track with reference tracks and listen to the same section.
STEP 3 - Click ZOOM OUT
Zoom out when you need to see the full song structure or move to another section.
LAST UPDATE: 2026-05-06
© 2026 Jamgather. All rights reserved.